25 CFM Refrigerated Compressed Air Dryer, 1-Phase 115 - 120VAC 60Hz

Description

Short Description
1.  Use stainless steel heat exchanger, high heat exchange efficiency and energy-saving
2.  HITACHI branded refrigerated compressor, R134a environment friendly gas
3.  All dryer with hot gas by-pass valve
4.  Condenser with blue hydrophilic film, good for rust-poof
5.  Delix or Schneider electrical components ensure the power supply
6.  Every KL dryer goes through 24hours quality testing before shipment
Description
Stainless steel plate heat exchange air dryer
Introduction
Plate heat exchange is a new type, highly efficient product which is made of corrugated metal pieces. The heat exchange
is processed by the plate. Compared with the conventional shell and tube type heat exchanger, under the same rate of the flow
resistance and pump power consumption, the heat transfer coefficiency is much higher.
Technical Upgrade
★ Ambient Temperature ≤104℉
★ Max.Pre.: 232psi
★ Inlet Temperature ≤104℉
★ Dew Point: 35.6-41℉
★ Refrigerant: R-407c, R-134a
Attention
The installation site No-dust, No-Oil. Site formation, 31 in. far away from the wall. According to the design of non-standard customized products.
Technical Details
BDL-5F Technical parameter table
Flow capacity
25CFM (Pressure P=101.33kPa、Temperature T=68℉ )
Design parameters
Inlet pressure
MAX232psi
Inlet temperature
≤113℉
Dew point
35.6-50℉
Ambient temperature
＜100.4℉
Refrigeration system
Refrigerant compressor
BSA645CW
Refrigerating capacity
878W (evaporation temperature44.96℉, condensation temperature129.92℉
Refrigerant type
R134A
Refrigerant weight
0.77lb
Condenser
plate fin type
Evaporator
Stainless steel plate fin type
Power system
Voltage
AC1Φ 115 - 120V 60Hz
Power
0.28kW
Refrigerant compressor
1/3 HP
Connect
Compressed air
NPT 1/2”
Drainage
Φ8
Additional Information
Model
BDL-05F
Length（Inch）
19 -2/3
Width（Inch）
11 -4/5
Height（Inch）
23- 5/8
Weight（LB）
66